DRAINLIFT TMP
Design
Wastewater lifting unit (floor-mounted installation)
Application
Wastewater lifting unit for the automatic drainage of showers, washbasins, washing machines/dishwashers, etc., in both old and new buildings where the wastewater cannot be discharged to the sewer system via natural slopes and/or for the disposal of wastewater that accumulates below the backflow level. For pumping non-aggressive wastewater and drainage waters that are free of faeces, fibre, grease and oil. Compliance with DIN EN 12050-2 and DIN 1986-100 is required.
Attention: Pumping sewage containing faeces in wastewater lifting units is not permitted. In these cases, it is necessary to use DrainLift KH32, DrainLift XS‐F, DrainLift S to XXL and FTS series sewage lifting units.
|
Type key |
Example |
Wilo-DrainLift TMP 32-0,5 |
TMP |
Wastewater lifting unit (floor-mounted) |
32 |
Nominal diameter of the pressure connection (DN 32, G 1¼) |
0,5 |
Nominal motor power [KW] |
Special features/product advantages
- Modern design
- Shower drains from height of 110 mm possible
- Low-noise operation
Materials
- Motor: Stainless Steel
- Hydraulic housing: Plastic
- Tank: ABS plastic
Technical data
- Mains connection 1~230 V, 50 Hz
- Cable length from system to switchgear/plug 1.2 m
- Operating mode S1 (1000 h, Tmax 45 °C), S3-10 % (Tmax 75 °C)
- Fluid temperature max. 45 °C, for short periods (3 min) 75 °C
- Pressure port Ø 32 mm (G 1¼)
- Inlet connection 40 mm (2 x G 1¼)
- Ventilation connection 25 mm
- Protection class IP 44
- Gross tank volume 17 l
- Switching volume 2.6 l